On the black Strida I’ve destryoed the 338 part definitely by too much force -
I’ve mounted the wheel and wondered, while tightening the bolt, that it didn’t become firm.
Therefore the bolt was unscrewed again and I saw the deformed 338 part…
On the silver Strida I’m not 100% sure, but I believe it was the same reason.
I guess that any force, applied to the wheel via the tyre in axle direction, should be absorbed by the wheels flexibility.
Hmmm, here I’m also unsure, sorry, but I think that the very gently tightening will be below 2 or 3Nm.
2Nm are the lowest amount which can be set on the BBB torque wrench, I do not trust the wrench at this range limit…
I’ll try to figure out a safe torque amount asap…