Mounting fenders..

So, I received my fenders today from Gum team in hong kong. I looked at my bike, I have the screw holes for the 18" fenders but no screws… Anyone can give me the specs to the screws needed?

Oh, sh…

You need not only the screws, you will also need the brass washers:
(different for upper and lower hole)

The bolts are common raised head sheet metal screws, diameter 4 mm with 18 mm length.

You shouldn’t use the screws without the stepped washers, most likely the fenders would be damaged and moreover that they will not fit exactly.
If you accept a set of used screws+washers, please pm me :wink:

Edited 06.09.
Reason: Haevy mind mistake, shame on me

The thicker stepped washer is for the bottom fender hole while the thinner one is placed at the top hole.

Thanks for the tip! Weird why I didn’t get them in first place…

Thanks for the tip! Weird why I didn’t get them in first place…

@ Chester_Tan
Thank you very much,of course you’re right!

@ tuchEWe3
I’m so sorry…but please don’t worry, the second set will arrive together with your bars in a few days :blush: